Every home depends on its storage water heater to deliver continuous hot water for daily tasks and activities. Installing or replacing a storage water heater demands simple knowledge of plumbing and electrical work. A homeowner who is adequately prepared can replace their storage water heater without professional help when they have essential tools.
This guide by https://www.plumbersingapore.org/our-services/ explains all the steps to install or replace storage water heaters securely.
Tools and Materials Needed
To begin setup, you need to collect specific tools and materials.
- New storage water heater
- Adjustable wrench and pliers
- Pipe wrench
- Teflon tape (plumber’s tape)
- Screwdrivers
- Drill (if mounting required)
- A bucket and towels alongside storage water heaters
- Safety gloves and goggles
- If required, get flexible water pipes for installation.
Placing a New Storage Water Heater
Step 1: Choose the Right Location
Choose a proper spot for your water heater installation. The installation site must be near the water main and power source. Set up the area with good airflow and enough room for future servicing.
Step 2: Shut Off The Water And Electricity
Stop water flow through the main valve before you start work. To avoid injury when working with an electric heater, turn off the power from the circuit breaker. To stop a gas-operated water heater, turn the gas valve into its off position.
Step 3: Put On Mounting Brackets
To support the weight of a wall-mounted heater, use a drill to fasten strong support brackets in the correct place. As per the product guidelines, place the device at specified positions.
Step 4: Connect the Water Supply
Feed the cold water from the inlet pipe while connecting the hot water outlet to the heater. Apply Teflon tape to threads before installing to keep leaks from forming. Wrap joint connections with a wrench while not twisting too hard.
Step 5: Place The Pressure Safety Feature
A pressure relief valve stops the system’s pressure from increasing too high. To ensure efficient functionality, follow the instructions specified by the producer. Installing the pressure relief valve is an important safety addition to the system.
Step 6: Connect the Power Supply
Set up the electric power supply connections to the water heater unit by aligning both ends with the correct grounding. Secure the gas line to your heater unit and inspect for any leaks by applying soapy water. You can get it done professionally by https://www.plumbersingapore.org/storage-water-heater-installation-and-replacement/.
Replace an Existing Storage Water Heater
You need to replace your water heater when it’s age, leaking, or energy waste makes it unusable. Follow these steps:
Step 1: Switch Both Water and Power to Off Positions
Depending on your heater type, press the circuit breaker and gas valve switch to the off position. Close the water supply before removing the part to avoid flooding.
Step 2: Drain the Old Heater
Connect the hose to the drain valve at the heater’s bottom. Open the valve to transfer water from the tank into a receptacle or floor outlet. To speed up draining, redirect hot tap water from your home.
Step 3: Disconnect Both Water and Power Supply Lines
Twist a wrench onto both the water inlet and outlet pipe ends to remove them. Turn off electric power when removing the heater components. Disconnect the gas line from the gas heater model with extreme caution.
Step 4: Remove the Old Unit
After disconnecting all parts, you need to safely remove the old heater. If the water heater feels too heavy to handle on your own, use assistance to move it correctly.
Step 5: Install the New Heater
Complete the installation process precisely, as explained before, including all tight cable joints.
Step 6: Turn On and Test
Before testing the new heater, turn on the water supply and let the tank refill. Then, verify whether the heater functions correctly by activating the power or gas supply.
